Lime Plaster Preparations

It's been a while, eh? I ended up taking off a good chunk of the summer for various reasons, but it's time to take advantage of the more reasonable temperatures and get back to work! This post is all about preparing the bathroom for lime plaster. Unlike clay plaster, lime can stand up to regular wetting once it is waterproofed with olive soap (more on that later). Below are various photos I took along the way.

Getting started at the bottom showing the tools of the trade.  

Note the short bits of lath used to provide the gap between sticks.

I placed two nails at each stud location: the first was with the nail gun,

which is quick and avoids splits in the ends.  The second was a stainless ring nai hammered by hand.

The larger head and extra gripping power is good protection against the final

wall pulling off from the studs in one big sheet.

Some areas couldn't be nailed due to the steel plates

that protect the plumbing.

This plywood section covers up the blocking that is in place
to support any cabinetry I may want to install in the future.
(I'm planning to build a bank of shelves to start with.)

Blocking between the i-joist flanges will get painted to match.
This will make  for nice finished look at the top of the wall, with the
ceiling panels sitting on top.

A temporary stop to create a clean edge for the lime.  After the wood strip
is removed, the final adobe will be toweled flush with the lime.

Making sure I don't drop any gobs of plaster  in the toilet riser pipe.

I made a small lath mock-up and spread a
test mix to see what it feels like.

I was especially curious to see how hard it is to achieve the "key",
where the plaster oozes through the slits in the lath.  Once hard,
this really locks the plaster onto the lath.